Filter
Top Products
8
Operation of wireless remote control con’t.
Introduction of Special Function
● Press SLEEP button to select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ), and cancel. Sleep cancel is
default setting.
● Sleep 1 in Cool and Dry modes: after one hour, the main unit setting temperature will
increase 1°C. After 2 hours the setting temperature increases to 2°C, the unit will run at this setting
temperature; In Heat mode: after two hours, the setting temperature will decrease 1°C, 2 hours, setting
temperature will decrease 2°C , then the unit will run at this setting temperature.
Temp Range Cool Mode Temp Range Heat Mode
Sleep 2
16-23°C + 1°C every hour up to 3°C 16°C N/A
24-27°C + 1°C every hour up to 2°C 17-20°C - 1°C after first hour
28-29°C + 1°C every hour up to 1°C 21-27°C -1°C every hour up to 2°C
30°C - 1°C after 7 hours 28-30°C -1°C every hour up to 3°C
● Sleep 3
(1) Under Sleep 3 mode, press and hold "Turbo" button continuously, remote control enters into user
individual sleep setting status. The time of remote control will display "1hour ", the setting temperature "88"
will display the corresponding temperature of last sleep curve setting and blink
(2) To change the set temperature, adjust by pressing "" and " " buttons. Press "Turbo" button to
confirmation;
(3) At this time, 1hour will be automatically increased at the timer position on the remote control, (that are "2
hours" or "3 hours" or " 8 hours "), the place of setting temperature “88” will display the corresponding
temperature of last setting sleep curve and blink;
(4) repeat the above (2)～(3) operation, until 8 hours temperature setting finished, sleep curve setting
finished, at this time, the remote control will resume the original timer display; temperature display will
resume to the original timer display; temperature display will resume to original setting temperature.
● Sleep 3
The user could accord to sleep curve setting method to inquire the presetting sleep curve, enter into user
individuation sleep setting status, but do not change the temperature, press "Turbo" button directly for
confirmation.
Note: Sleep function can not be set under the Fan and Auto mode. Under Dehumidify mode, only Sleep 1
can be set. When selecting the Sleep mode function, the Quiet function is set automatically, different Quiet
status could be optional and turned off.