Sharp AF-R100CX Air Conditioner User Manual


 
16
Insert the batteries in the compartment,
making sure the and polarities
are properly aligned.
HOW TO OPERATE
USING THE REMOTE CONTROL
INSTALLING BATTERIES
Use two size-AAA (R03) batteries.
Battery compart-
ment cover
NOTES:
The battery life is approximately one year with normal use.
When you replace the batteries, always use two new ones of the same type.
If the remote control does not operate normally after replacing the batteries, take out the
batteries and replace them again after 30 seconds.
If you will not be using the unit for a long time, remove the batteries from the remote control.
ATTACHING THE REMOTE CONTROL HOOK
Remove the backing from the remote control hook.
Attach the hook onto the left side of the unit's
cabinet.
To prevent loss, hook the remote control on the
cabinet when not in use.
Front Panel
Remote control hook
Cabinet
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit's re-
ceiver window and press the desired button. A
beep will sound when the unit receives the signal.
Make sure no objects, such as curtains, block the
receiver window.
The remote control operates from up to 20 feet (6
meters) away.
The beep will also sound when each pad on the
control panel is touched.
CAUTION:
Do not expose the receiver window to direct sunlight. This can adversely affect its operation. In
such case, close the curtains to block the sunlight.
Use of a fluorescent lamp in the same room may interfere with the transmission of the signal.
The unit may be affected by signals emitted from the remote control of a television, VCR or other
equipment used in the same room.
Do not leave the remote control exposed to direct sunlight or near a heater. Protect the remote
control from moisture and shock which can discolor or damage it.
2
1
Remove the battery compartment cover.
3
Replace the cover.