Filter
Top Products
Using Your Motorized Brush
1. Make sure that the vacuum is in the
"Off" position.
2. Firmly insert the
motorized brush
(Fig. 8) into the
air-intake nozzle
of the dust cup
container ensuring
that the contact
pins are
engaged in the
connector slots
of the unit. (Fig. 9)
Note: This motorized brush is for
vacuuming short pile carpets, rugs
or upholstery.
WARNING: Do not touch the
motorized brush while it is in motion.
Fig. 8
Fig. 9
Metal
contact
pins
Dust Cup
Release
Button
Fig. 5
OPERATING INSTRUCTIONS
5
Assembly
Note: The filter must always be
used when operating the hand
vacuum.
1. To open the dust cup container,
press the dust cup release button
and remove the dust cup container.
(Fig. 5)
2. Verify that the filter is inside, then re-
attach the dust cup container to the
hand vacuum. (Fig. 6)
Fig. 6
3. To attach the crevice tool to the hand
vacuum, push the
attachment into the
suction hole in the
front of the dust
container. (Fig. 7)
CAUTION: The suction inlet must be
open and free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
Fig. 7
Using Your Cordless Vacuum
1. Unplug unit from charger.
2. To start the unit, slide the "On/Off“
switch to the "On" position.
3. To stop the hand vac, slide the
"On/Off" switch to the "Off" position.
4. A crevice tool is provided for
cleaning narrow, hard to reach
places. A motorized brush is
provided for cleaning low pile
carpets or upholstery.
Changing & Cleaning the Filter
To achieve the best performance,
empty the dust cup container and
clean the filter after each use.
1. To remove the dust cup container,
press down on the dust cup release
button and pull off the dust cup
container.
2. Pull out the filter.
3. Empty the dust
from the dust cup
container.
(Fig. 10)
4. Rinse the filter in
cold water, and then wait until it air
dries completely before replacing it
back into the dust cup container.
Do not use a washing machine to
clean the filter. Do not use a hair
dryer to dry it. Air dry only.
CAUTION: The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will
overheat and could become damaged.
Warning: Always empty the dust cup
container and clean the filter before
each use and during prolonged usage.
Never over fill the dust cup (container) -
remove dirt and clean the filter and
frequently during prolonged usage or
risk motor damage.
If you wash the filter, make sure that
it is completely air dry before
inserting back in the vacuum.
Note: The filter is washable. It should,
however, be replaced every three (3) to
six (6) months, depending on usage to
ensure peak performance of your
vacuum.
Fig. 10
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
HAND VACUUM
WILL NOT
OPERATE
1. Batteries discharged.
2. No power in electrical
outlet supplying
transformer.
1. Charge unit.
2. Check fuse or breaker.
Replace fuse/reset
breaker.
HAND VACUUM
WILL NOT PICK-
UP OR SUCTION
POWER IS WEAK
1. Dust cup container is
full.
2. Filter needs cleaning
or replacement.
3. Unit needs
recharging.
1. Empty dust cup
container
2. Remove filter and check
for object(s) in air duct
and remove. Clean or
replace filter.
3. Charge unit.
MOTORIZED
BRUSH WILL NOT
WORK
1. The 2 metal pins of
the motorized brush
are not in contact
with the vacuum
cleaner.
2. Motorized brush is
clogged up.
1. Firmly insert the
motorized brush into
the air-intake nozzle.
This will connect the
motorized nozzle to the
unit power supply.
2. Remove all lint, hair etc.
from motorized brush.
DUST ESCAPING
FROM HAND
VACUUM
1. Dust cup container is
full.
2. Filter is not installed
correctly.
3. Puncture/hole in
filter.
1. Empty dust cup
container.
2. Review the filter
installation instructions.
3. Replace the filter.
6
OPERATING INSTRUCTIONS
Please Note: The filter is washable. It should, however, be replaced every three
(3) months to ensure peak performance of your vacuum.
Important: Make sure that filter has completely air dried before
re-installing back in the hand vacuum.
REPLACEMEN PARTS FOR MODEL SV769
Replacement dust cup filter SKU# XF769
Replacement battery pack SKU# XB768
To order replacement batteries or filters or for technical support:
Call: 1 (800) 798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
or
visit our website: www.sharkvac.com