Shark SC507 Carpet Cleaner User Manual


 
TIPS ON HOW TO USE YOUR SYSTEM
ADDITIONAL IMPORTANT SAFEGUARDS
Fiberglass or Stainless Steel Surfaces
Use the bristle brush. Slowly move the
brush over the surface to be cleaned.
The vapor will emulsify the dirt and
grease on the surface. Follow behind
with a terry cloth towel over the brush to
remove excess moisture and residue.
Tip: An old idea for polishing stainless
steel is to wipe it down with seltzer soda
water after it is cleaned.
Bathroom Areas
To clean the bathtub or shower area, use
the bristle brush for grout, shower door
tracks, hard to get areas and heavily
soiled areas. The dual edge window/tile
squeegee will be the most efficient way
to clean the rest of the area. Allow plenty
of time for the heat to penetrate the
surface. This is especially helpful in the
shower area if there is tile or grout. Wipe
with towel.
Removal of soap scum on tile, grout, and
shower doors is also easier with the
steam cleaner.
To clean sanitary fixtures, use the
concentrator with or without bristle brush.
Use a terry cloth towel or paper towel to
wipe up excess moisture and residue.
To clean the sink and faucets, use bristle
brush then finish by wiping with a towel.
Soap Scum
Soap scum dissolves almost immediately
under a combination of heat and
moisture. Rinse the surface with a small
amount of water afterwards or go back
over it once more with a clean terry cloth
towel.
Note: Soap scum sometimes will develop
a hard surface from waterborne minerals.
If this is the case, use the bristle brush to
break up this surface - or spray or wipe
first with lemon, vinegar or seltzer soda
water to soften the minerals.
Moving too slowly can dry out the soap
scum and cause it to granulate on the
surface. The surface will have a gritty
feel. If this happens, apply vapor to the
surface with the bristle brush again and
re-clean.
Garden Furniture
Use any of the brushes depending on the
surface area. Work quickly when
cleaning resin outdoor furniture. Finish by
wiping with a towel.
Blinds
Use the nylon bristle brush to clean
blinds. Move the brush over the
surface, allowing enough time for the
vapor to penetrate. Work quickly on
PVC blinds. Test for color fastness on
fabric blinds before using. Finish by
wiping with a towel.
Automotive
For detailing the wheels, use the
concentrator and the bristle brush.
Exterior windows are cleaned best by
applying the vapor with the concentrator
and following with a paper towel.
To clean bicycles, use the bristle brush.
To clean equipment, use the bristle
brush, depending on the surface area.
Finish by wiping down with a towel.
Artificial Plants
Use the concentrator without a brush
attached to blow off the dust and dirt.
Clothing
A vapor cleaning system is excellent for
removing wrinkles from fabrics. Simply
“vaporize” the surface from a distance
(12”-18”) The dry vapor removes
wrinkles without leaving the fabric wet
like ordinary fabric steamers do.
Nicotine and Tar
Nicotine and tar dissolves at high
temperatures and becomes a light
yellow oil that has the consistency of
sewing machine oil. When the
nicotine/tar film is touched by steam
pocket, it immediately dissolves and
flows into the steam pocket towel. You
can remove it from flat surfaces as fast
as you can move the steam pocket over
the surface.
Removing Wax, Tar, Etc.
Many stains are only stuck on the
surface of materials and can be easily
and quickly removed by “blowing”
excess material away from the surface
from the side. This is accomplished by
using the concentrator. Hold the terry
cloth towel to the side to catch the loose
residue as it is blown by the
concentrator. Note: Always vacuum
any loose residue off the surface before
you apply vapor to it.
1. To avoid circuit overload, do not operate another appliance on the same socket
(circuit) as the steam cleaner.
2. If an extension cord is absolutely necessary, an extension cord rated a minimum
of 15 ampere, 14 gage cord should be used. Cords rated for less amperage may
overheat. Care should be taken to arrange cord so that it cannot be pulled or
tripped over.
3. Do not leave unattended when the system is connected to a power
supply/electrical outlet.
WARNING: This appliance is equipped with a grounded,
type 3-wire cord (3-prong plug). This plug will only fit into an
electrical outlet made for a 3-prong plug. This is a safety
feature. If the plug should fail to fit the outlet, contact an
electrician to replace the outlet. Do not attempt to defeat the
safety purpose of the grounding pin, part of the 3-prong plug.
CAUTION: Always drain condensed water from hose
before use or if unit has been left idle for a period of time. To
drain hose, direct nozzle into an appropriate container or sink
and depress hand grip steam trigger. Once hose has been
drained, normal use may be resumed. Never direct nozzle
towards people, animals or plants.
WARNING: Your Steam Cleaner is designed to clean hard surfaces
and upholstery that will withstand high heat. Do not use on soft plastics
and cold glass. On surfaces that have been treated with wax or some no
wax floors, the sheen may be removed by the heat and steam action. Do
not use on unsealed wood. This could cause the wood grain to rise. It is
therefore recommended to test an isolated area of the surface to be
cleaned before proceeding.
IMPORTANT: Do NOT add cleaning solutions, scented perfumes, oils or
any other chemicals to the water used in this appliance.
Use regular water or distilled/purified water if the tap
water in your area is very hard.
WARNING: Danger of Scalding. Please use caution when using the
steam cleaner. The steam emitted from this opening is very hot.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
2 11