Filter
Top Products
2
TOLL FREE: 1-800-798-7398
3
www.SharkVacThenSteam.com
English
ASSEMBLY
1 Slide the Telescopic Handle into the
cleaning unit until it locks into place.
Once in position, you never have to
remove the handle.
2 For your comfort, you can adjust the
height of the handle. To do so pull
the latch down on the handle tube
90 degrees to the open position.
Holding the handle, extend the tube
to the height that is right for you and
then close latch to lock into position.
Getting Started: Assembly
When assembling your Vac-Then-Steam™
there may be a little water in or around
the water tank. This is because we
quality test all our Shark products before
distributing them, so you get a quality
Shark
®
Vac-Then-Steam™.
3 Wrap cord around cord holders and
secure plug to cord.
NOTE: The Vac-Then-Steam™, is a
complete bare-floor cleaning and
sanitizing system. It comes “vacuum-
ready” out of the box.
QUICK TIP: For easier pushing and
pulling, extend the height of the
handle by using the telescopic latch
on the pole.
1
2
3
i Mop Handle
j Quick Release Swivel Cord Wrap
k Cord Clip
l Telescopic Handle Latch
m Carry Grip
n Vacuum and Steam Mode Panel
o Water Tank Cap
p Water Tank Viewing Window
q Post-Motor Filter Access
r Dust Cup
a Telescopic Handle
b Cleaning Unit with Dust Cup
c 1 All-Purpose Cleaning Pad and
1 Heavy Duty Cleaning Pad
d Steam Frame
e Storage Tray
f Filling Flask
g 1 Replacement Post-Motor Filter
h 1 Replacement Dust Cup Filters Set
b
a
d
f
h
e
j
i
l
m
n
r
q
p
o
k
c
g
MV2010WC_11_IB_ENG_100803.indd 2-3 04/08/10 9:37 AM