Filter
Top Products
• Place one end of new belt over
motor shaft and the other on the
round pulley end of the beater bar.
• Before re-inserting the agitator
assembly, make sure that the end
caps are on correctly. (fig. R)
12. Cleaning & Changing the Belt
cont.
• After checking the caps, re-install
the agitator assembly into the
housing grooves.
• Turn the agitator by hand to make
sure that the belt is not twisted and
all rotating parts turn freely.
• Replace the rear belt cover and
screw firmly.
Fig. R
13. Changing the Headlight Bulb
Caution: The two end caps may
come off along with the two washers
as you lift the agitator unit out. Do
NOT
lose the two small washers.
Warning: Always disconnect from
power source when servicing or
cleaning the unit. Failure to do so could
result in electrical shock or personal
injury from cleaner suddenly starting.
• Turn unit “Off” and unplug from
wall outlet.
• Use a Phillips screwdriver and
remove the four (4) screws from the
top of the motorized power head
cover. (See fig. O on page 7)
• With the base cover removed, insert
bulb into the socket and twist
clockwise. (fig. S)
Fig. S
OPERATING INSTRUCTIONS cont. PROBLEM SOLVING
Note: Always replace the light bulb
with the same or smaller wattage size
(12V 4W) to prevent damage to the
surrounding parts.
14. Motor Thermostat
Important: This motor is equipped
with a motor protective thermostat. If
for some reason the vacuum cleaner
should overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the
power source.
• Check the source of
overheating problem. (i.e.
clogged hose or filter)
• if clogged hose or filter is
found, unclog the hose and
replace the filters.
• Wait at least 20 minutes
before attempting to reuse the
vacuum.
• After unit has cooled down for
20 minutes, plug in the cleaner
and push the On/Off button.
The vacuum should start
again.
• If the vacuum still does not
start, contact EURO-PRO at
1-800-798-7398.
This appliance was inspected thoroughly and was in good operating condition
when it was shipped from the factory. If a minor problem occurs, it usually can
be solved quite easily when the cause is found. Therefore, this checklist is
provided for your convenience.
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
CLEANER WON'T
RUN
1. Not firmly plugged in.
2. No electricity in wall plug.
3. Blown fuse/tripped
breaker.
1. Plug unit in firmly.
2. Check fuse or breaker.
3. Replace fuse/reset
breaker.
CLEANER WON'T
PICK UP
1. Broken or worn belt.
2. Hose end not securely in
place.
3. Dust cup is full.
4. Weak suction force.
1. Replace belt.
2. Push hose in firmly.
3. Empty dust cup.
4. Hose is clogged.
Remove hose and
remove obstruction.
CLEANING
ACCESSORIES
WON'T PICK UP
1. Dust cup is full.
2. Hose is clogged.
1. Empty dust cup
container.
2. Remove hose and
remove obstruction.
8 9