Filter
Top Products
2
FAMILIARISEZ-VOUS AVEC VOTRE ASPIRATEUR-
BÂTON TURBO SHARK
Spécifications techniques
Tension : 120 V, 60 Hz
Puissance : 7,5 amp, 900 watts
OPERATING INSTRUCTIONS
Replacing The Dust Cup Into The
Unit
• Hold the dust cup in your hand.
• Make sure that the slot on the bottom
of the cup is pointed in the same
direction as the pins in the
unit. (Fig. 16)
• Slide the dust cup inside to the end of
its place in the unit. (Fig. 17)
• Turn the dust cup 90° clockwise.
( Fig. 18)
• The unit is now ready to be used
again.
Attaching the Shoulder Strap
Use the hooks to attach the shoulder
strap to the vacuum cleaner.
Connect the dog leash swivel hooks
to the eyelets located near the top of
the unit handle and at the base of the
unit. (Fig. 19) Adjust the strap as
required for comfort.
Warning: After extended use, the body
of the vacuum cleaner may become hot.
When using the unit with the shoulder
strap, the unit will touch the body of the
user. Therefore make sure to use the
vacuum cleaner with the strap only when
the unit is cool. If it gets too warm, allow it
to cool before continuing to use it.
Motor Thermostat
Hook for
Shoulder
Strap
Hook for
Shoulder Strap
Fig. 19
7
IMPORTANT: This unit is equipped
with a motor protective thermostat. If for
some reason the vacuum cleaner should
overheat, the thermostat will
automatically turn the unit off. Should
this occur:
• Push the On/Off button once.
• Disconnect the plug from the power
source.
• Check the source of overheating
problem. (i.e. clogged hose or filter).
• If clogged hose or filter is found,
unclog the hose and replace the
filters.
• Wait at least 45 minutes before
attempting to reuse the vacuum.
• After unit has cooled down for 45
minutes, plug in the cleaner and push
the On/Off button. The vacuum should
start again.
• If the vacuum still does not start,
contact customer service at
1 (800) 798-7398.
16
17
18
9. Coupelle A Poussière
10. Brosse A Planchers
11. Raccord Du Boyau
12. Fiche Électrique
13. Suceur Plat
14. Brosse A Épousseter
15. Bandolier
1. Poignée En 2 Pièces
2. Joint De La Poignée
3. Poignée
4. Entrée D’air Latérale
5. Boîtier Principal
6. Commutateur Marche/Arrêt
7. Boyau
8. Filtre De Type-HEPA