Filter
Top Products
ENFORCER Outdoor Stand-Alone Keypads Quick Programming Guide
2 SECO-LARM U.S.A., Inc.
Program new Master Code immediately.
Program the Output #1 access mode immediately, or the keypad will only accept
user cards.
Take note of the keypad status LEDs—
o Right LED Green: Standby
o Left LED Solid Red/Right LED Solid Orange: Programming Mode
o Right LED Flashing Orange: Awaiting code/card entry
If unsure of which mode the keypad is in, press until the right LED is green.
The keypad is now in the standby mode. Enter the master code twice to return to
Programming Mode.
For complete programming instructions, see page 10 of the User Manual.
Programming Tips
*SK-2323-SPQ and SK-1323-SPQ only.
Setting the Output #1 Access Mode*
DEFAULT: User card only. To use codes, you MUST set mode to or .
2. Enter .
0
0
0
User card ONLY (DEFAULT)
Either user card OR user code
0
1
Note: The Output #1 Access Mode must be programmed in order for the
SK-2323-SPQ and SK-1323-SPQ to accept user codes.
3. Enter one of the following:
0
2
User card AND user code
1. Enter Programming Mode by entering the Master Code twice.
4. Exit Programming Mode by pressing .
1. Enter Programming Mode by entering the Master Code twice.
(Default Master Code is 12345)
2. Enter .
3. Enter the new 5-digit Master Code twice.
Programming the Master Code
3
Example: If the desired new Master Code is 54321, enter:
5
4
3
2
1
5
4
3
2
1
4. Exit Programming Mode by pressing .
0
1
0
2