Filter
Top Products
ENFORCER Covert PIR Camera
SECO-LARM U.S.A., Inc. 3 SECO-LARM U.S.A., Inc. 33 3
1. Run a 12VDC power supply wire and
a video cable with a male BNC
connector through the wall to where
the camera will be mounted.
2. Connect the camera’s video and
power cables.
3. Do a preliminary test of the camera to
ensure it will work properly at that
location.
4. Remove the bracket (if attached)
by gently wiggling it while
Installation:
1. Please read this manual carefully and
keep it for future reference.
2. Use the camera within given temperature
and electrical limits.
3. Do not mount the camera where it is
exposed to rain or other moisture, or in
humid or dusty places.
4. Do not point the camera at the sun. Heat
could damage the camera, even when
not in use.
5. Do not mount the camera in areas
exposed to radiation, strong magnetic
fields, or strong electrical signals.
6. Do not open or disassemble the camera.
There are no user-serviceable parts inside.
7. Do not drop the camera or subject it to
strong vibrations.
Before Starting:
Overview:
Important:
Do not cut the DC jack or the female BNC
connector as this will void the warranty.
Female BNC connector
DC Plug with terminal block
pulling it downward, off the camera.
5. Partially screw a screw into the wall where
the top of the bracket should go. Slide the
bracket onto the screw. Finish securing
the top of the bracket to the wall.
6. Secure the bottom of the bracket to
the wall.
7. Attach the camera to the bracket by sliding
the camera downward.
8. Do a final test of the video camera and
monitor.
Camera
DC jack
Mounting bracket
Slide camera
downward onto
the mounting
bracket