Sears PD6801 Air Conditioner User Manual


 
iNSTALLATiON iN
Typlo_l S_dO D|schsrge
[nsta!lat[on demands con_ection of blower opening to existing
air ducting system or to a dropper duct with a ceiiing diffuser.
In either insta_ce, building modification is ne(ess[tated. The
bottom discharge cooler is always moul_ted on the roof of
the structure_ You will require a roof stand, roof jack, flexible
duct and collar to connect to existing ductwork.
DO NOT [)RIVE NAILS OR SCREWS INTO BOSOM OFTHE
WET SECTION OF TItlE COOUR, TI4tS WiLL CAUSE iT TO
LEAK WATER AND WILL VOID THE WARRAN1_Y,
Whenever the cooler is mounted, the surface must be [eve[.
When coolers are installed in the city of LosAngeles they must
only be installed outside of buildings.
AJ[of the electrical components that are part of this product
shall be either currently listed as part of the equipment for
intended use by a Los Angeles City recognized electrical
testing laboratory, or currently approved by the City of Los
Angeles Electrical Testing Laborato_.
La insta[acion dema:_da la conexion de la descarga de la
unidad a el existente sistema de ductos o a una caida de ducto
con difusor de de[o. En ambos casos, ]a modificacion del
edificio es necesaria.Elenffiador de descarga inferior siempre
semo_ta en [aestructura de[ techo. Para esto serequiere ur_
soporte de angulos, soporte de iamina ducto fiexiNe Y un
collar para conectar[o a] ducto existente.
NO CLAVE CLAVOS O TC)RNILLOS EN El,.FONDO DE LA
SECCION HUMEDA DEL ENFRIADOR_ ESTO CAUSARA
FUGAS DE AGUA Y ANULARA LA GARANI'IA.
Cuando un enfriador es montado, Jasuperfide debe estar
nivelada.
Cualquier enfriador que sea instaJado en la ciudad de Los
A%eJes tiene que set instaiado solamente en el exterior de[
edificio.
Todos los componentes electricos que son parte de este
producto deben estar corrientemente listados como parte del
equipo para el uso que se intente pot el [aboratorio de
pruebas electricas de ka Ciudad De Los Angeles 0
Corrientemente Aprobado Pot Este.