Filter
Top Products
SECTION 2 HOW YOUR WATER SOFTENER WORKS
2A. FACE PLATE TIMER FEATURES
EXTRA RECHARGE
Sometimes, a manually started
(recharge) may be desired, or
examples are:
regeneration
needed. Two
- -You have used more water than usual (guests
visiting) and you may run out of soft water
before the next timer started regeneration.
- - You did not refill the softener with salt before it
was gone.
You can start a regeneration right away, or you
can set the timer to regenerate at the next 2:00
AM (or other preset recharge time). Do the
following.
RECHARGE NOW
• Press the ON/OFF-
HOLD button and holduntil
RECHARGE NOW, SERV
and FILL begin to flash in
the display. Upon reaching
fill, the first cycle of regen-
eration, the flashing SERV
goes off and FILL is on
steady. RECHARGE NOW
continues to flash. This re-
generation will last for
about 2 hours. After the 2
hours, you will have soft
water again.
mm
RECHARGETONIGHT
• Press and release (do not
hold) the ON/OFF-HOLD
button. RECHARGE TO-
NIGHT flashes in the dis-
play, and the softener be-
gins regeneration at the
next preset recharge time.
Press and release the ON/
OFF-HOLD button once
more if you decide to cancel
the regeneration, and RE-
CHARGE TONIGHT.
$
llms
IImJ
m4
Ima_
m_
SALT MONITOR SYSTEM
The face plate timer has a low salt monitor with
an indicator light to remind you to refill the
storage tank with salt. To set this monitor system:
1, Lift the salt hole cover and level the salt in the
storage tank.
e
The salt level decal, on the brinewell inside
the tank, has numbers from 0 to 8 (see
drawing on page 9 and below). Observe the
number the leveled salt is at or closest to.
NOTE: To light the salt storage area, press the
TANK LIGHT button on the face plate.
o
Now, press the SALT LEVEL ADJUST button
until black bars display up to the salt level
number. For example, the pictures below
show the salt level at 6.
e
Finally, set the level you want the low salt
indicator light to come on. Press the SIGNAL
LIGHT ADJUST button until a (÷) shows
opposite this number. In the example below,
the light will come one when the stored salt
drops to level 2. At level 2, the storage tank is
about 1/3 full. This is the lowest you should
allow the stored salt level to drop to. To turn
the salt monitor off, press the button until
OFF shows.
salt
level
/
m
SALT
LEVEL
8_
I
7
6
brinewetl
decal
indicator
light
s,,, \0
MONITOR
SYSTEM
m3
m2_
/
black
boxes
NOTE:
For accurate salt monitor operation, always use
nugget or pellet water softener salt. See page 9.
10