Filter
Top Products
UNPACKING
ASSEMBLY
(For 110,000 Btu/Hr
Model Only)
1. Remove all packing items applied to heater for shipment.
2. Remove all items from carton.
3. Check items for shipping damage. If heater is damaged, promptly inform dealer
where you bought heater.
This model is furnished with wheels and a handle. Wheels, handle, and the
mounting hardware are found in the shipping carton.
Tools Needed
• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer
1. Slide axle through wheel support frame. Install wheels on axle.
IMPORTANT. When installing wheels, point extended hub of wheels toward
wheel support frame (see Figure 3).
2. Place cap nuts on axle ends. Gently tap with hammer to secure.
3. Place heater on wheel support frame. Make sure hot air outlet end (front) of
heater is over wheels. Line up holes on fuel tank flange with holes on wheel
support frame.
4. Place plastic tube caps onto open ends of handle.
5. Place handle on top of fuel tank flange. Make sure handle is over air inlet end
(rear) of heater. Insert four screws through handle, fuel tank flange, and wheel
support frame. Attach nut finger tight after each screw is inserted.
6. Insert remaining four screws through tank flange and wheel support frame.
Attach nut finger tight after each screw is inserted.
7. After all screws are inserted, tighten nuts firmly.
Plastic
Tube
Cap
\
",,\ Screw
Hot Air , _"l
Outlet \\
Handle
Fuel
Tank .....
Flange
Air
Inlet
Wheel Axle
Support
Frame "--..
Nut
-. Extended
" Wheel Hub
Cap Nut
Figure 3 - Wheel and Handle Assembly, 110,000 Btu/Hr Model Only
100506