Filter
Top Products
3,CARINGFORTHE MACHINE
CLEANING THE FEED DOGII
ITH A BRUOH
To insure the belt poulble operation of your
machine, It il neceaury to keep the essential
parle clean at all tJnlo|,
I, Removebobbin cover plate,
2. Remove needle plata.'
3, Usingthe brush provided, remove the lint
that accumulate In and around the feed
dogs and shuttlearea,
CLEANING AND OILING
SHUTTLE AREA
On occasions, you wil! need to clean the
shuttlearea, Just follow these simple steps,
2,
Turn hand wheel toward you until needle
is above feed dogs,
Remove bobbin case by lifting it out from
front,
3. Clean the shuttle with the brush end put e
drop of oil to the points Indicated by
arrows. Don't over.oil. (Reminder: don't
use household oll..,Kenmora sewing
machine oli,)
NOTE: Kenmore Oil/Oiler No, 6890 is avail-
able at most Seers retail stores and
catalog,
REPLACING BOBBIN CAEE
_d 1,
Jd
10
Make sure needle is above feed dogs,
insert bobbin case into shuttle until its
groOve fits on shuttle raceway as
illustrated, and then snap down into
position,
Replace both needle plate end bobbin
coverplate totheir originalpositions,
doge
51