Filter
Top Products
ASSEMBLYOF RECOVERY TANK
AND SOLUTION TANK
See Figure 2
1, Place Recovery Tal& into Solution Tank (align the word
"VACUUM" on Recovery Tank with "VACUUM" on
Solution Tank) and secure with Metal Latch.
2, Insert the plug on the Short Cord from the Solution Tank
into the Recovery Tank Power Head.
ASSEMBW OF HOSE, WANDS,
NOZZLE AND SOLUTION TUBING
See Figure 1
1. Assemble the two Straight Wands.
2. Assemble the upper Straight Wand to the Angled Wand
of the Hose.
3, Assemble the Floor Nozzle to the lower Straight Wand.
NOTE: Be sure locking button engages properly when
assembling straight wands, angled wand, and floor
nozzle,
4. Push the Solution Tube Quick-Disconnect Nut onto Trig-
ger Valve. Twist clockwise to lock, See DETAIL "A" -
Figure 3.
5. Push Solution Tube into Retaining Clips on Wands. Tub-
ing may be wrapped around Wands to take up excess
slack.
6. Attach the Vacuum Hose to Recovery Tank inlet
(Vacuum halet).
7. Push solution tube quick disconnect nut onto the quick
disconnect valve. Turn clockwise so valve posts lock into
notches in nut. See DETAIL "B" - Figure 3.
NOTE: To remove metal retaining clips from hose and solution
tube, squeeze tube with fingers before removing, Clips will dislodge
easily. Also squeeze tube before reattaching clips to prevent hose
punctures.
O0wER
RD
POWER
HEAD
PLUG
SHORT
CORD
HERE
RECOVERY
TANK
SHORT
CORD
\
TANK
LATCH
TRIGGER
VALVE
SOLUTION TUBE
NUT
l
RETAINING
CLIP
SOLUTION TUBE QUICK
DISCONNECT NUT
QUICK DISCONNECT
VALVE
DETAIL "B"
HOSE
lING
CLIP