Sanyo THX1852 Air Conditioner User Manual


 
15
Adjusting the Airflow Direction
4-way (X) air conditioner is equipped with auto flaps.
You can set the airflow direction to a specific angle or to the sweep mode using the remote
control unit.
Do not move the flap with your hands.
4-way type (X) The air outlet flap can be easily removed and washed with water.
Be sure to always stop operation before removing the flap.
After washing with water, allow it to dry, and then remount it with the arrow facing outward.
Ceiling mounted type (T)
A. Vertical directions (automatic)
This air conditioner is equipped with an auto flap. You can set the airflow direction to a specific
angle or to the sweep mode using the remote control unit. (Refer to the description of the
remote control unit.)
Do not move the flap with your hands.
B. Horizontal directions (manual)
The horizontal airflow direction can be adjusted manually by moving the vertical vanes to the
left or right.
Wall mounted type (K)
A. Vertical directions (automatic)
Confirm that the remote control unit has been turned on. Press the FLAP button to start the flap
moving up and down. If you want to stop the flap movement and to direct the air in the desired
direction, press the FLAP button again. In the cool mode, don’t direct the flap down more than
30°, otherwise, condensation may drip on to the floor. Zone ‘‘A’’ is the recommended flap
position for cooling.
Do not move the flap with your hands.
B. Horizontal directions (manual)
The horizontal airflow direction can be adjusted manually by moving the vertical vanes to the
left or right.
30°
Indoor unit
Zone ‘‘B’’ for
heating
60°
Zone ‘‘A’’
for cooling
OI-837-15-EG