Filter
Top Products
Care and Cleaning
1. For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
2. Do not pour water on the indoor unit to clean it. This will damage the
internal components and cause an electric shock hazard.
Air intake and outlet side
(Indoor unit)
Clean the air intake and outlet side of the indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild liquid
detergent. When cleaning the air outlet side, be careful not to force the vanes
out of place.
1. Never use solvents or harsh chemicals when cleaning the indoor
unit. Do not wipe plastic parts using very hot water.
2. Some metal edges and the fins are sharp and may cause injury if
handled improperly; be especially careful when you clean these
parts.
3. The internal coil and other components of the outdoor unit must be
cleaned every year. Consult your dealer or service center.
Air filter The air filter collects dust and other particles from the air and should be
cleaned once every two weeks or when
the filter indication ( ) on the display of the remote control unit (wired type) shows
that the filter needs cleaning. If the filter gets blocked, the efficiency of the air
conditioner drops greatly.
CAUTION
01_SPW-XDR94GXH56_EN.fm Page 34 Thursday, January 22, 2004 9:07 PM
How to remove the filter
1. Grasp both ends of the air intake grille and pull to open it.
2. Hold the air filter by the tab and pull it upward. Clean the air filter.
3. When replacing the filter, make sure that the FRONT mark is facing you.
Reinsert the filter into place and close the air intake grille.
FILTER CLEANING
Use a vacuum cleaner to remove light dust. If there is sticky dust
on the filter, wash the filter in lukewarm, soapy water, rinse it
in clean water, and dry it.
"AIR CLEAN" FILTER
(ACCESSORY SUPPLIED ON REQUEST)
●
The air filter is to be added by springs to the standard filter.
●
It is made of two layers:
- the first layer consists in a synthetic honey comb high efficiency
media to remove the dust and purifing the air.
- the second layer in charcoal media deodorizing the ambient
air.
How to install the "Air clean" filter.
1. Open the unit intake air grille and pull out the standard air
filter.
2. Apply on the rear side of the filter the two spings supplied with
the accessory.
3. Fix the "air clean" filter by the springs.
4. Insert the two air filters one over the other and close the intake
grille.
REAR SIDE OF
ANTI-MOLD FILTER
SPRING
“AIR CLEAN” FILTER
(HIGH EFFICIENCY
HONEYCOMB AND
CHARCOAL MEDIA)
2
1
F
R
O
N
T
3
7. APPENDIX
17