Filter
Top Products
Input power : 1800W
Input voltage : 230-240V , 50Hz
Protection class: class ll
Power cord length: 5m
Dust capacity : 2L
If you have a problem with your cleaner, consult the handy guide as below. If
the cleaner is malfunctioning, do not operate it before asking for service.
Problem Possible Solution
Noisy operation
Low Suction
Clean the filter and clean up the inside of the dust cup.
Clean or replace the filter.
Remove the blockage.
Put the dust cup in place.
Over-heating/
Automatically Stopping
Clean the filters, and clean up the inside of the dust cup.
Check for blockages and unblock and allow it to cool.
Plug unit firmly.
Decrease of the
vacuum power
If the vacuum power decrease, rinse the HEPA filter and
the exhaust filter
Cannot Find
the Combination
Nozzle
Nozzle is clipped into a compartment at the bottom edge
on the back of the vacuum cleaner (between the wheels).
It is a single attachment.
Floor Brush hard to
push
Due to the strong suction power, it may be difficult to push,
especially thick carpet. Rather than to use the floor brush
forcibly, lift up the Floor Brush momentarily. It allows air to
flow into the vacuum releasing and built up suction
pressure, and then do well to push floor brush.
Slide and open the suction adjuster located on the hose
handle grip. This will reduce suction power of the floor
head.
Cord doesn’t fully
rewind
Pull out the cord and rewind again.
Trouble Shooting
Technical Specification
7