Filter
Top Products
TROUBLESHOOTING
10
If there is a problem with the vacuum cleaner, carry out the following checks
to find the cause. If the problem still persists after the checks have been
made, do not use the vacuum cleaner to prevent the possibility of an accident
occurring. Turn the ON/OFF switch to the " " position, disconnect the power
cord from the wall outlet, and contact the place of purchase or your nearest
Sanyo self-servicing dealer, or call(toll-free) 1-800-421-5013 (USA Only).
Problem
Possible cause
Motor does not operate when
the switch is depressed to the
"ON" position.
Is the cord plugged completely into the power outlet?
-Check the connection of the cord into the power outler for
complete insertion.
Is the cord damaged where it is connected to the plug, or are
you pulling on the cord too hard or bending it?
-Have the cord replaced at a Sanyo self-servicing dealer or a
Sanyo service station.
Is the electrostatic micron filter dirty?
-Replace the electrostatic micron filter.
Is the turbine brush or the hose clogged?
-If so, clean it out.
Suction does not improve
after replacing the bag.
The agitator dose not operate.
(SC-180 only)
The lever is not set to the RUG position?
-Set the lever to the RUG position.
Is the turbine brush or the hose clogged?
-If so, clean it out.
REPLACEMENT PARTS
Be sure to use only genuine Sanyo replacement parts.
Paper bags, electrostatic micron filters and other replacement parts can be
obtained from your nearest Sanyo dealer.
If there is on Sanyo dealer in your vicinity, please contact a Sanyo service
center or call(toll-free) 1-800-5013 (USA Only).
Part Name & lllustration
SC-P11
Paper bag
SC-F2
Electrostatic micron filter