Filter
Top Products
14
CARE AND CLEANING
Casing and Grille (Indoor Unit)
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild
liquid detergent. When cleaning the grille, be careful not to force
the vanes out of place.
Anti-Mold Filter
The anti-mold filter behind the front panel should be checked and
cleaned at least once every two weeks.
How to remove the anti-mold filter
Grasp both ends of the front panel and pull forward and up to open
the front panel. Lift the anti-mold filter up slightly to disengage the
protrusions from the hooks on the unit, and then pull downward to
remove the filter from the unit.
Cleaning
Use a vacuum cleaner to remove light dust. If there is sticky dust
on the filter, wash the filter in lukewarm, soapy water, rinse it in
clean water, and dry it.
How to replace the anti-mold filter
Insert the top of the anti-mold filter, and then fit the protrusions on
the bottom of the filter all the way into the hooks on the unit.
Press the locations marked by the arrows and close the front
panel.
Air Clean Filter
The air clean filter removes dust and dirt from the air, and reduces
odors and smoke from tobacco.
How to install the air clean filter
The air clean filter needs to be installed behind the anti-mold filter.
Open the front panel and remove the anti-mold filters, then install
the air clean filter in the position shown in the figure. After that,
remount the anti-mold filters and close the front panel.
• Do not bend nor give excessive force onto the air clean filter.
• If the filter surface is heavily blocked with dirt or damaged, replace it
with new one. Purchase a replacement filter at your local dealer.
(model STK-FWWB)
Cleaning the main unit and remote control unit
• Wipe clean using a soft, dry cloth.
• To remove stubborn dirt, moisten a cloth in warm water no hotter
than 40 °C, wring thoroughly, and then wipe.
• The front panel can be removed in order to wash it with water.
Removing and remounting the front panel
1.
Open the front panel until it is nearly horizontal, grasp the
sections near the front panel arms on both sides, and then
remove the panel by pushing the arms towards the outside
while pulling the panel towards you.
2. Grasp the sections near the front panel arms on both sides,
and hold the front panel so that it is nearly horizontal. Push the
arm shafts towards the outside so that they come into contact
with the top of the indentations on the right and left sides of the
air conditioner. Then push firmly until the arm shafts click into
place. After closing the front panel, press firmly on the parts
indicated by the arrows to securely fasten the panel in place.
Also refer to the figure that shows “How to replace the anti-
mold filter”.
Washing the front panel with water
• Clean the front panel gently using a soft sponge, or the like.
Then wipe away any remaining moisture.
• Neutral detergent may be used to remove stubborn dirt. Then
rinse thoroughly with water and wipe away any remaining
moisture.
1. For safety, be sure to turn the air
conditioner off and also to
disconnect the power before
cleaning.
2. Do not pour water on the indoor unit
to clean it. This will damage the
internal components and cause an
electric shock hazard.
1. Never use solvents, or harsh
chemicals when cleaning the indoor
unit. Do not wipe the plastic casing
using very hot water.
2. Some metal edges and the fins are
sharp and may cause injury if
handled improperly; be especially
careful when you clean these parts.
3. The internal coil and other
components of the outdoor unit
must be cleaned every year. Consult
your dealer or service center.
CAUTION
Front panel
Anti-mold filter Protrusions
This air clean filter cannot remove
harmful gases or vapors nor ventilate
air in the room. You must open doors
or windows frequently when you use
gas or oil heating appliances.
Otherwise there is a risk of suffocation
in extreme cases.
When using a footstool or the like, be
careful not to let it tip over.
Air clean filter
NOTE
Front panel Arm
CAUTION
OI-018-14-EG
SAP-K97GAX_EN.fm Page 14 Tuesday, January 22, 2008 6:34 PM