Filter
Top Products
2
2 - 10
F: FLAP button ( ) 1. Use this button to set the airflow direction to a specific angle.
The airflow direction ( ) is displayed on the remote control unit.
• In the cool mode and dry mode, when the flaps are set in a
downward position, condensation may form and drip around
the vent.
• Do not move the flap with your hands.
This function is available only for models X and T.
()2. Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the ( ) symbol appears on
the display.
This function is available only for models X, T and K.
.
G:TIMER SET button Use this button while the unit is operating to switch between timer
settings:
(OFF Timer) :The air conditioner stops after the length of time set.
(OFF Cycle Timer) :The air conditioner after the same set time every time.
(ON Timer) :The air conditioner starts after the length of time set.
H:Time setting buttons :Press this button to increase the time.
:Press this button to decrease the time.
I: SET button Use this button to set the timer.
J: CL button Use this button to clear the timer setting.
K: SENSOR A temperature sensor inside the wireless remote controller senses the
room temperature when switched from a temperature sensor inside the
indoor unit.
L: VENTILATION button Use this button when you installed a ventilation fan available in the
market.
Pressing this button turns on and off the fan.
When turning off the air conditioner, the fan will be also turned off.
While the fan is operating, will appear in the display.
M:TRANSMITTER When you press the buttons on the wireless remote controller, the
mark appears in the display to transmit the setting changes to the
receiver in the air conditioner.
N: ADDRESS button By pressing the ADDRESS button of the remote controller, the display
of the remote controller indicates the current address. If this address
matches with the address of the controller in an indoor unit, the buzzer
will beep. The buzzer will always beep if the indicated address is “ALL”.
If the indicated address is “ALL”, you can operate any of your indoor
units regardless of their setting of controller addresses. Direct the
remote controller to the remote control receiver of the indoor unit you
want to operate and send a signal. (See p.11, How to set the
ADDRESS.)
Remote Control Unit (continued)
NOTE
NOTE
Operation mode
(COOL) or (DRY)
(HEAT) or (FAN)
(AUTO)
Cooling mode:
Heating mode:
Number of airflow direction settings
3
5
3
5
NOTE
NOTE
05-368 PAC-i_IM_Sec2 12/7/05 4:36 PM Page 10