Filter
Top Products
Adjusting the Airflow Direction
A. Horizontal (Wall-mounted type only)
The horizontal airflow can be adjusted by moving the vertical vane to the
left or right.
B. Vertical
Confirm that the remote control unit has been turned on. Press the FLAP
button to start the flap moving up and down (
). If you want to stop the
flap movement and to direct the air in the desired direction, press the FLAP
button again. In the COOL mode, don’t direct the flap down more than 30 °
(KHS, THS Types), or leave it in the vertical position (XHS Type), otherwise
condensation may drip onto the floor. Zone ‘‘A’’ (KHS, THS Types) and any
position other than vertical (XHS Type) are the recommended flap positions
for cooling.
CAUTION
Do not move the flap with your hands.
Operation without the Remote
Control Unit
If you have lost the remote control unit or it is not working, follow the steps
below.
1. When the air conditioner is stopped.
If you want to turn on the air conditioner, switch the operation selector to
the OFF position, and then to the ON position.
NOTE
The set temperature and fan speed are automatically set at the
last selection before stopping.
2. When the air conditioner is running.
If you want to turn off the air conditioner, switch the operation selector to
the OFF position.
Indoor unit
(Wall-mounted type)
Zone
‘‘A’’
for
COOLING
Left
Vertical
vane
Right
30°
STANDBY
INDOOR UNIT
Operation
selector
Flap
(Wall-mounted type)
21OI-212-21EG
oi212001
Air outlet
grille
Flap
Down
Up