Filter
Top Products
Step 2
Attach Upper Cord Hook
Pull the spring on the electrical cord
upward toward the top of the handle.
Make sure slots in handle are positioned
properly, see Detail A.
Insert the lower half of the spring into the
upper cord hook (B), as shown. Snap the
hook into the upper handle, directions
below.
H
G
E
F
Step 4
Install The Bag
Insert the bag adapter clip (E) on the
bottom of the bag collar into the bag
adapter retainer (F).
Push the bag collar up and forward so
the locator lug slides into the slot
indicated by the arrow. Then turn the
cam latch (G) to lock the bag onto the
rivet (H).
Loop the spring from the top of the bag
onto the bag support located to the back
of the upper cord hook (B).
Step 3
Attach Lower Cord Hook
Insert the power cord into the lower cord
hook (C), as shown. Snap the hook into
the lower handle. Pull up on the cord to
tighten but leave enough slack near the
base so the cord is not strained when the
handle is lowered. Wrap the cord around
the two cord hooks. Fasten the plug to
the cord to prevent unwinding.
3. SNAP opposite inner
tab into place
1. Place inner tab
into slot
2. Press hook
around handle
7
B
BAG
SUPPORT
HOOK