Filter
Top Products
3
HOW TO ASSEMBLE
CAUTION: Completely assemble vacuum cleaner before
using.
A
2-Part
Bolt
B
Upper
Cord Hook
C
Lower
Cord Hook
D
Bag
Screws
Assembly Packet is with ownerʼs guide.
B
Detail A
Detail A
C
A
A
Step 1
Attach the Handle
Push the handle sections together. Note: Check to be sure
slots in handle are correct, see Detail A.
Align the holes in the handle. Insert a 2-part bolt (A) in the
center of the handle and tighten.
Push handle into the handle socket so handle grip curves
away from the cleaner. Align the holes, insert the other 2-part
bolt (A) and tighten.
D
Step 2
Attach Upper Cord Hook
Pull the flexible cord support up toward the top of the
handle.
Insert the lower half of the cord support into the upper cord
hook.
Check to be sure slots in handle are correct, see Detail A.
Place inner tab of cord hook into handle slot as shown (1)
and press hook handle (2) SNAPPING opposite inner tab
into place (3).
Step 3
Attach Lower Cord Hook
Insert the power cord into the lower
cord hook. Snap the hook into the
lower handle.
Pull up on the cord to tighten but
leave enough slack near the base
so there is no strain on the cord
when the handle is lower.
Step 4
Store Electrical Cord
Wrap the cord around the two cord hooks. Fasten the plug
to the electrical cord to prevent unwinding.
Step 5
Attach Outer Bag
IMPORTANT
: To provide a good gasket seal, the bag
coupling must seat fi rmly against the motor
base and not overlap the furniture guard.
Hold outer bag with zipper away from the handle. Start the
bag screws (D) by hand, then tighten with a screwdriver.
Loop the bag spring onto the bag support hook on the back
of the upper cord hook.
3. SNAP opposite
inner tab into
place
1. Place inner
tab into slot
2. Press hook
around
handle
B
Flexible
Cord
Support
Lower Cord Hook
Upper Cord Hook
Bag
Support
Support
Hook
Hook