Filter
Top Products
Step 2
Attach Upper Cord Hook
Pull the flexible cord support up toward the top
of the handle.
Insert the lower half of the cord support into the
upper cord hook.
Check to be sure slots in handle are correct,
see Detail A. Place inner tab of cord hook into
handle slot as shown (1) and press hook handle
(2) SNAPPING opposite inner tab into place (3).
Step 3
Attach Lower Cord Hook
Insert the power cord into the lower cord hook.
Snap the hook into the lower handle.
Pull up on the cord to tighten but leave enough
slack near the base so there is no strain on the
cord when the handle is lower.
Step 4
Store Electrical Cord
Wrap the cord around the two cord hooks.
Fasten the plug to the electrical cord to prevent
unwinding.
Step 5
Attach Outer Bag
Important: To provide a good gasket seal,
the bag coupling must seat
firmly against the motor base
and not overlap the furniture
guard.
Hold outer bag with zipper away from the handle.
Start the bag screws (D) by hand, then tighten
with a screwdriver.
Loop the bag spring onto the bag support hook
on the back of the upper cord hook.
3. SNAP opposite inner
tab into place
1. Place inner tab
into slot
2. Press hook
around handle
6
B
Bag
Support
Hook
Flexible
Cord
Support
Lower Cord Hook
Upper Cord Hook