Filter
Top Products
5
BRUSH AND PAD DRIVER
INSTALLATION
To install a brush or pad driver, leave the handle in the upright
position and tip the machine backwards so it rests on its wheels
and upper handle section (Fig. 4). The brush and pad driver
both attach in the same manner: align the cutouts on the inner
ring of the brush or pad driver with the tabs on the inside of
the ring of the drive hub (Fig. 5). Push the brush or pad driver
firmly in position, then turn it counterclockwise until it locks
into place.
To remove, turn the brush or pad driver clockwise until it stops,
then lift it off. Note: Always remove the brush or pad driver
when the machine is not in use.
CAUTION: Disconnect the power cord from the electrical
outlet before installing a brush or pad driver.
Fig. 4
ON
OFF
CAUTION: Disconnect
the power cord from the
electrical outlet before
installing a brush or pad
driver.
Fig. 5
PAD CENTERING LOCK (Model 20” 1500 rpm 1.5
HP only)
To install a pad, tip the machine backwards so it rests on
the rear wheels and handle. After centering the pad on the
pad holder, insert the Pad Centering Lock and twist it
clockwise until it securely locks in place. To remove twist the
lock counterclockwise.
DRIVE BELT ADJUSTMENT
(Model 20” 1500 rpm 1.5 HP only)
CAUTION: Disconnect the power cord from the electrical
outlet before adjusting drive belt tension.
1. Loosen the bolts holding the drive motor to the frame; do
not remove (Fig. 6).
2. Turn the two screws at the rear of the frame until the belt
is tight.
3. Test the machine. If belt slips, adjust further. Retest. If
the belt does not slip, tighten the drive motor bolts. DO
NOT overtighten the drive belt.
ADJUSTMENTS
Fig. 6
Adjusting Bolts
HANDLE ADJUSTMENT
The handle can be adjusted to any desired work position by
simply pushing up on the handle lock (Fig. 7). Move the
handle to the desired position, then firmly push down on the
handle lock which will lock the handle in position.
Fig. 7
Lock
Unlock