Filter
Top Products
E-
9
Cooling Your Room
Power
Control Panel
You must select the Cool mode if you wish to lower the temperature
in your room. You can also set the Fan speed.
Press the (On/Off) button.
Result:
The air conditioner is fitted with a protection mechanism to prevent
the unit from being damaged when it is started immediately after
being:
Plugged in
Stopped
It will start up normally after three minutes.
If the temperature is not displayed on the control panel:
Press the button on the unit one or more times until the
temperature is displayed.
The unit beeps each time you press the button.
The air conditioner starts up in the Cool mode.
You can chang modes at any time.
Each time you press the or buttons:
- The temperature is adjusted by 1 F and displayed on
the control panel
- The unit beeps
To set the fan speed:
Press the button on the unit one or more times until the
desired the Fan speed(F1, F2 or F3) is displayed.
To control the direction of the air flow, refer to page 24.
To adjust the temperature, press the or buttons on the unit one
or more times until the desired temperature is displayed.
The temperature can be set between 64 Fand 86 F.
Result:
Result:
The air conditioner starts up in the cool mode.
The unit beeps twice.
1
2
3
4
5
Mode
Cool/Dry/Fan
Mode
Cool/Dry/Fan
Fan Speed
The air conditioner starts cooling, if the room temperature is
higher than the selected temperature.
If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
Low
Medium
High