Filter
Top Products
E-10
Removing Excess Humidity
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
You can operate the Dry mode only by using the control panel.
1 If necessary, press the (On/Off) button.
Result
: ◆ The air conditioner starts up in the mode selected when
the unit was last used.
◆ The unit beeps.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
It will start up normally after three minutes.
2 If the
“ ”
indicator is not displayed at the top of the control panel,
press the button on the control panel one or more times until it
appears.
Result
: ◆
The unit beeps each time you press the button.
◆
The air conditioner runs in Dry mode.
➢
You can change modes at any time.
The “ ” passes through the control panel.
3 To adjust the temperature, press the
or
buttons one or
more times until the required temperature is displayed.
Possible temperatures are between
64°F and 86°F
inclusive.
Result
: ◆ Each time you press the
or
buttons:
- The temperature is adjusted by 1°F
- The unit beeps
◆ The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
4 To control the direction of the air flow, refer to page 11.
Remote Control
Control Panel
☛