Filter
Top Products
E-
17
Cooling Your Room
1
If necessary, press the (On/Off) button.
Result:
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
Plugged in
Stopped
lt will start up normally after three minutes.
If the is not displayed at the top of the remote control,
press the button on the remote control one or more times until it
appears.
Result:
The unit beeps each time you press the button.
The air conditioner runs in the Cool mode.
2
You can change modes at any time.
To adjust the temperature, press the buttons one or more times
until the required temperature is displayed.
Possible temperatures are between 64 F and 86 F inclusive.
Result:
Each time you press the buttons:
- The temperature is adjusted by 1 F
- The unit beeps
The air conditioner starts cooling, if the room temperature
is higher than the selected temperature.
If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
3
Select the fan speed by pressing the button one or more times
until the required setting is displayed:
Low
Medium
High
Result
: Each time you press the button, the unit beeps.
4
To control the direction of the air flow, refer to page 24.
5
You must select the Cool mode if you wish to adjust the:
Cooling temperature
Fan speed when cooling
The air conditioner starts up in the Cool mode.
The unit beeps.