Filter
Top Products
Solving Common Problems
Technical Specifications
Model
Power Supply
AW0700A
AW0700B
AW0800A
AW1000A
AW1010A
AW1200A
AW1210A
AW1800A 230V~/208V~, 60Hz
Design and specifications are subject to change without notice.
Explanation / Solution
◆ Check for a power failure.
◆ Check the voltage.
(See the technical specifications)
◆ Check the power plug for disconnection.
◆ Check to see whether the operating mode selection dial is placed in the
"OFF" position. (Set it to the desired position.)
◆ Check to see whether the room temperature is too low.
- Refer to page 10 for details about temperature condition.
◆ Set the THERMOSTAT control to the desired position.
- When the number on the THERMOSTAT control is high,
the room temperature may be too warm.
◆ Check to see whether there is any open window or leakage of cool
air to the outside.
- Close the window, and fill the gap.
◆ Check to see whether there is any obstacle adversely affecting
the flow of the air inside and outside the room.
- Remove the obstacle or change the position of the air conditioner.
◆ Check to see whether the air filter is clogged with dust or
contaminated with foreign substances.
- Clean the air filter.
◆ Check to see whether there is any direct sunlight facing the air conditioner.
- Block the sunlight with a sunshade.
◆ Check to see whether there is any electric device generating heat.
- Do not use the air conditioner together with any heating device.
◆
Ventilate the room.
Problem
The air conditioner
does not operate at all.
The air comes out smoothly,
but cooling is not effective.
Odors are permeating the
room during air conditioning
Before contacting an authorized service center, perform the following simple checks.
They may save you the time and the expense of an unnecessary call.
Cooling Capacity(BTU/h)
7000
7000
8000
10000
10000
12000
12000
115V~, 60Hz
18000
E-
13
◆ Check that the air conditioner has been switched on;
if necessary, turn the operating mode selection dial.
; refer to page 9.
The air flow direction does not
change when you set the air
flow blade swing switch to the
position