Filter
Top Products
E-
15
Solving Common Problems
Technical Specifications
Explanation / Solution
◆ Check that the circuit breaker used for the air conditioner has not been
triggered.
◆ Check that the power cable is plugged into a wall socket and the socket is
switched on, if necessary.
◆ Check that the temperature indicator on the unit is lit; if necessary,
press (On/Off) on the remote control or unit.
◆ Check that there are no obstacles between you and the unit.
◆ Replace the remote control batteries if necessary.
◆ Check that you are close enough to the unit (seven metres/yards or less).
◆
Ventilate the room.
Problem
The air conditioner does
not
operate at all
The air conditioner does not
operate with the remote
control
Odors are permeating the
room during air conditioning
◆ Check that you are pointing the remote control at the remote control sensor
on the unit.
◆ Replace the remote control batteries if necessary.
No beep is heard when you
press (On/Off) on the
remote control
◆ Check that the correct operating mode has been selected(COOL).
◆ The room temperature may be too low.
◆ Dust may be blocking the air filter; refer to page 14 for cleaning instructions.
◆ Check that there is no obstacle blocking the air flow into or out of the unit.
The air conditioner does not
cool
◆ Check that the air conditioner has been switched on; if necessary,
press (On/Off) on the remote control or unit.
◆
The blades may not move when the air conditioner runs in the energy saving mode.
The air flow direction does
not change when you press
the Swing button
◆ Check that the timer has been programmed correctly; refer to page 11.
The timer is not correctly
triggered
Before contacting an authorized service center, perform the following simple checks.
They may save you the time and expense of an unnecessary call.
Design and specifications are subject to change without notice.
Power Supply
115V~, 60Hz
Model
AW0690
AW0890
AW1090
AW1290
Cooling Capacity(BTU/h)
6000
8000
10000
12000