Filter
Top Products
E-15
Install the unit in the window.
4-1 Lift unit into center of opened window.
Use hand grips on top sides of unit as an aid in lifting
and positioning unit.
4-2 Rest bottom of unit against outside edge of inner window sill.
Be sure bottom edge of unit fits down into “L” bracket (type “E”).
4
Attach the seal strip to the window.
3-1 Cut the adhesive-backed foam seal strip gasket to the window width.
3-2 Remove the backing from the seal strip and attach the strip to
the underside of the bottom window.
3
Extend the window filler panels.
5-1 Extend the window filler panels into the window sash tracks
on both sides. When the window is pulled down, the window should
rest on the unit just behind the window filler panel frames.
5-2 Slide the window filler panels outward until they touch the sides
of the window.
Secure the both sides of the window filler panels using
the 2 type “A” wood screws provided.
Install the 2 type “C ” window filler panel clamp to each side of lower
the window filler panel frame as shown in the figure by using
the 2 type “A” wood screws.
Install the 2 type “D ” window filler panel clamp to each side of upper
the window filler panel frame as shown in the figure by using
the 2 type “A” wood screws.
5
Install the window gasket.
Cut the foam window gasket to the window width and stuff it between the
window and the glass to prevent air and insects from getting into the room.
6
“L” Bracket (Type “E”)
Type “A” screws
Type “A” screw
Window filler panel clamp (Type “C”)
Window filler panel
clamp (Type “D”)