Filter
Top Products
Solving Common Problems
E-10
Explanation / Solution
◆ Check for a power failure.
◆ Check the voltage.
(See the technical specifications)
◆ Check the power plug for disconnection.
◆
Check to see whether the SELECTOR is placed in the "OFF" position.
(Set it to the desired position.)
◆ Check to see whether the room temperature is too low.
- Refer to page 8 for details about temperature condition.
◆ Set the THERMOSTAT control to the desired position.
- When the number on the THERMOSTAT control is high, the room
temperature may be too warm.
◆ Check to see whether there is any open window or leakage of cool
air to the outside.
- Close the window, and fill the gap.
◆ Check to see whether there is any obstacle adversely affecting
the flow of the air inside and outside the room.
- Remove the obstacle or change the position of the air conditioner.
◆ Check to see whether the air filter is clogged with dust or
contaminated with foreign substances.
- Clean the air filter.
◆ Check to see whether there is any direct sunlight facing the air conditioner.
- Block the sunlight with a sunshade.
◆ Check to see whether there is any electric device generating heat.
- Do not use the air conditioner together with any heating device.
Problem
The air conditioner
does not operate at all.
The air comes out smoothly,
but cooling is not effective.
Before contacting an authorized service center, perform the following simple checks.
They may save you the time and the expense of an unnecessary call.