Filter
Top Products
Heating Your Room
(Except Cooling Only Models)
E-
23
ENGLISH
You must select the HEAT mode if you wish to adjust the :
◆ Heating temperature
◆ Fan speed when heating
1
If necessary, press (ON/OFF) button.
Result:
◆ The On/Off indicator on the wired remote controller comes on.
◆ The air conditioner runs in the mode selected when
◆ the unit was last used.
The air conditioner is fitted with a protection mechanism to
prevent the unit from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
lt will start up normally after three minutes.
IMPORTANT
To select the HEAT mode, press the Mode button until is displayed at
the top of the wired remote controller.
Result:
◆ The air conditioner runs in HEAT mode.
2
You can change modes at any time.
NN
NN
oo
oo
tt
tt
ee
ee
To adjust the temperature, press the Temperature buttons one or more times
until the required temperature is displayed. Possible temperatures are between
16
O
C and 30
O
C inclusive.
Result:
◆ Each time you press Temperature buttons:
- The temperature is adjusted by 1
O
C.
◆ The air conditioner starts heating, provided that the room
◆ temperature is lower than the selected temperature ;
◆ the fan will, however, operate.
3
Select the fan speed by pressing the Fan button one or more times until
the intended value is displayed :
4
Automatic(rotated : ➔➔)
Low
Medium
High
You can select the HEAT mode only in heat pump models.