Filter
Top Products
E-11
ENGLISH
Selecting the Heat Mode
Result:
Each time you press the button, the indoor unit beeps.
For the first 3~5 minutes, the fan may not operate to prevent
the cool air from running out of the indoor unit.
It helps to warm the air in your room sufficiently.
You can select the Heat mode if you want to heat your room.
You can adjust the temperature and the fan speed when heating.
1
To control the airflow direction, refer to page 16.
5
You can change modes at any time.Note
Press the button on the remote control until is displayed.
Result:
The indoor unit beeps each time you press the button.
The air conditioner runs in the Heat mode.
2
Press the
button to adjust the temperature until the required
temperature is displayed.
You can set the temperature between 61°F(16°C) and 86°F(30°C).
Result:
Each time you press the
button:
- The temperature is adjusted by 1°F
- The indoor unit beeps
If the room temperature reaches 9°F higher than the set tempera-
ture, the air conditioner stops heating, but the fan operates consis
-
tently.
If the room temperature reaches 5°F lower than the set
temperature, the air conditioner starts heating again.
3
Press the
button to select the fan speed until the required setting is
displayed.
Automatic (rotated :
)
Silence mode
Low
Medium
High
Maximum
4
If necessary, press the button.
Result:
The operation indicator on the indoor unit lights up.
The air conditioner starts up in the mode you selected last.
The indoor unit beeps.
Note
Silence mode( ) makes the noise quieter during
operating the indoor unit in the Heat mode.
ÃÀÖÞÏò_DB98-27555A_IB_E.indd 11 2007-3-5 19:20:10