Samsung AM27A1C07 Air Conditioner User Manual


 
Purging the Unit
On delivery, the indoor unit is loaded with an inert gas. All this gas
must therefore be purged before connecting the assembly piping.
To purge the inert gas, proceed as follows.
Unscrew the caps at the end of each pipe.
Result: All inert gas escapes from the indoor unit.
To prevent dirt or foreign objects from getting into the pipes
during installation, do NOT remove the caps completely
until you are ready to connect the piping.
Connecting the Assembly Cable
The indoor unit is powered from the outdoor unit via the assembly
cable. If the outdoor unit is more than five metres away from the
indoor unit, the cable must first be extended to a maximum of
ten metres.
1 Extend the assembly cable if necessary.
2 Open the front grille by pulling on the tabs on the lower right and left sides
of the indoor unit.
3 Remove the screw securing the connector cover.
4 Pass the assembly cable through the rear of the indoor unit and connect
the assembly cable to terminals 1 to 5.
Each wire is labelled with the corresponding terminal number.
5 Pass the other end of the cable through the 65 mm(2 inch) hole in the
wall.
6 Replace the connector cover, carefully tightening the screw.
7 Close the front grille.
8 For further details on how to plug the other end of the assembly cable into
the outdoor unit, refer to page 36.
1 2 53
1
1
(L)
2
(N)
2 53
1 2 53 4
1
1
(L)
2
(N)
3
COM
3
COM
4
FAN
2 53 4
INSTALLING THE INDOOR UNIT
Indoor
unit
Assembly
cable
AM27A1C07/AM27A1C13
AM18A1C09/AM26A1C13
Outdoor
unit
Indoor
unit
Assembly
cable
Outdoor
unit
Earth terminal
Earth
terminal
Earth
terminal
Earth terminal
16
9
E-
32