Filter
Top Products
ENGLISH
10
Z
17
DESCRIPTION OF COMPONENTS - FEATURES
DESCRIPTION OF COMPONENTS
1
2
3
4
5
7
10
9
8
6
Control panel
Dehumidified air outlet grid
Air inlet filter holder grid
Condensation collection tank
“Air in bloom
®
” system
Washable filter
Highly efficient filter with activated charcoals (when provided)
Direct drainage hole cap
Direct drainage pipe (when provided)
Fragrance container on top of “Air in bloom
®
” system
LIST OF COMPONENTS - FIG. A - Z
EXCLUSIVE FEATURES
“AIR IN BLOOM
®
” SYSTEM (FIG.Z)
This equipment is provided with an exclusive “Air in bloom
®
” system; you may choose among a
variety of fragrances to pleasantly scent your home by simply proceeding as follows:
• remove the desired fragrance tablet from the packet;
• turn the cover counter clockwise (10) (Fig.Z);
• place the scented tablet horizontally in the appropriate guides;
• close the cover (10) (Fig.Z) again by turning it clockwise.
The fragrance tablets last for approximately 24 hours, after which time they are to be replaced,
following the procedure described above.
Use only original Saeco
®
products that may be purchased through authorised retailers.
HIGHLY EFFICIENT FILTER WITH ACTIVATED CHARCOALS (7)
Thanks to this accessory the Saeco
®
dehumidifier is capable of filtering the conditioned air in order to eliminate dust, pollen etc.
The highly efficient filter with activated charcoals is fitted standard on the “Mirage combi” models and may be installed also on
machines in which the filter is not provided, by purchasing it from an authorised dealer.
This filter must be replaced after a maximum of 3 months use.
OTHER FEATURES
ANTI-DRIP DEVICE
The Saeco
®
dehumidifier is provided with a device that prevents water from dripping when the condensation collection tank is
removed, to protect the inside the equipment and your floor from wetness.
ELECTRONIC DEFROSTING
The Saeco
®
dehumidifier is provided with a device that electronically controls the defrosting process.
DIRECT DRAINAGE
The Saeco
®
dehumidifier enables the continuous drainage of the condensation into an appropriate drainage point. To enable this
option, refer to the “installation with direct drainage” section.