Filter
Top Products
Attach tank brace to wheel shaft support using small screws,
star washers, and small nuts. Use 10 mm socket wrench
and box end wrench to fully tighten. FULLY TIGHTEN ALL
SCREWS ON CART!
Attach caster brackets to front of cart frame using small
screws, star washers, and small nuts. Ensure open end of
caster brackets face down. Use 10 mm socket wrench and
box end wrench to fully tighten.
1
1
Open end
2
11
x4x4
x4x4
x2x2
HH
x4x4
FF
G
GG
8
1
M
2
9
Assembly
Tools needed
13mm
10mm
13mm
10mm
1
x4
F
Q
GG
HH
x4
FF
x4
2
Q
F
3
x2
x2
x2x2
x2
P
HH
FF
GG
4
x2x2
x2
x2
x2
HH
GG
FF
N
Attach axle support to cart frame using small screws, star
washers, and small nuts. Hand tighten.
Turn cart frame over. Note orientation of notch in axle support.
Align diagonal supports with holes on side of cart frame (while
ensuring spring loaded buttons face inside of cart). Attach diagonal
supports to cart frame using small screws, star washers, and small
nuts. Hand tighten.
Attach vertical supports to side of cart frame using small screws,
star washers, and small nuts. Ensure support nests are pointed
towards front of cart. Hand tighten.
5
x2
x2
x2
II
JJ
GG
Attach diagonal supports to vertical supports with black coated
screws, star washers, and black coated nuts. Hand tighten.
2
7
1
KK
LL
MM
Attach bolt, lock washer, and nut to wheel shaft support. Use
13mm socket wrench and box end wrench to fully tighten.
8
1
2
10
x2x2
FF
x2x2
HH
x2x2
GG
O
ENGLISH
Attach tank retaining bracket to wheel shaft support. Align
lower tab with slot. Tighten tank release knob halfway.
6
Use 10mm socket wrench and box end wrench to fully tighten
all screws, star washers, and nuts.
Flip frame over. Check that frame is properly assembled.
Temporarily place tank on frame.
Important: Ensure cart is
assembled correctly before proceeding.
Lay cart back.
9
12
D