Filter
Top Products
TROUBLESHOOTING
Does not run
Operates for short time only
Runs but not cooling
Does not run and water full indicator lights
If the surge protector is tripped. Press the reset button the the LCI plug.
Please wait for 3 minutes and start again, protector device may be preventing
unit from working.
If batteries in the remote control need replacement.
If the plug is not properly plugged in.
If the set temperature is close to room temperature, you should lower the set
temperature.
Air outlet may be blocked by obstacle. Take the obstacle away.
If the door or window is open.
If there is other appliance heating room, such as heater or lamp, etc.
Check air filter, clean if necessary.
Air outlet or intake may be blocked.
Set temperature is too high.
Drain the water into an ample container by the drainage pipe on the rear panel
of the unit.
If still doesn't work, please consult a qualified technician.
Trouble
Analysis
The following cases may not always be a malfunction, please check it before asking for service.
9
ARP-1000ES