Filter
Top Products
If you have any doubts concerning installation possibilities for this heater, please consult a qua-
lified electrician.
Children, the elderly and the infirm may not always be fully aware of the danger involved in using
electrical appliances. Never allow this appliance to be used without supervision.
4 - INSTALLATION
The appliance must be secured to the wall, in a horizontal position.
Never install in vertical position as it may damage the heating element and render the
warranty null and void.
Never install your heater below a wall socket.
Radiation is quite intense in the vicinity of the appliance and objects placed in this area can get
very hot. You must therefore install your heater more than 60 cm from any inflammable objects
(e.g. curtains, clothes).
Your appliance has three mounting (1) enabling it to be adjusted to a horizontal level. (fig. 2)
Using the mounting template printed outside the packaging, mark holes to be drilled in the wall,
making sure that the minimum distances are respected (fig. 1 and 2).
Before drilling the holes in the wall, make sure that the plugs and screws supplied with the
appliance are suitable for your type of wall ; as an indication, the appliance weighs 1.5 kg.
Dismantle the external unit (7) by unscrewing the two screws (8).
Mod. IR 100-IR 150 : Insert the mains power lead in the internal unit (9) through the grommet
(2). You may use the optional cable guide (10) to position correctly the mains supply cable.
Secure the internal unit (9) to the wall with the three mounting holes (1), making sure your
appliance is horizontal.
Mod. IR 100-IR 150 :
Unscrew the 2 lead clamp screws (11) to release the upper section.
Connect the neutral (blue lead) to the terminal marked N (3), and the live phase to the termi-
nal marked L (3).
Fix again the lead clamp (11) to lock the mains supply lead.
Reassemble the external unit (7) with screws (8) and fit the screw covers (4) (supplied in the
accessory bag).
Be careful not to touch the quartz tubes with your fingers to avoid stains.
5 - OPERATION
The appliance is switched on by means of the pull switch (5). The slight vibration noticeable when
the appliance is switched on stops after a few seconds.
6 - OUTPUT
IR100 model
- Position 0 : stop
- Position 1 : 750 W (intermediate power)
- Position 2 : 1500 W (full power)
ENG
Before installing your appliance, you must disconnect the electrical supply at the circuit
breaker.
NOTICE_IRB_5940/A 24/09/02 16:44 Page 10