Filter
Top Products
English PLEASE READ CAREFULLY AND KEEP IN A SAFE PLACE
You have just purchased a fan heater, ideal for quickly heating the different rooms in your house.
This highly compact appliance can be easily stored or moved around from one room to another for
your comfort.
WARNINGS : It is essential that you read these instructions carefully and comply with the following
recommendations.
This appliance complies with European directives 73/23/EEC and 89/336/EEC.
Before using, always check the condition of the appliance, the power socket and the power lead.
Do not pull the appliance using the power lead.
Do not pull the power lead to unplug the appliance.
Keep the appliance 30 cm away from any objects (curtains, walls, aerosols, etc.)
Do not place the power lead near a source of heat (e.g. a hot plate) or a flame.
Do not place the appliance immediately below a wall mounted power socket.
Never insert objects into the appliance (e.g. needles...).
When in use, this appliance must be kept out of the reach of young children and animals.
Do not use your appliance in a dusty room or a room where there is a risk of fire.
This appliance is intended for domestic use only. It must therefore not be used in industrial appli-
cations.
The warranty will be void in the event of damage arising from improper use.
If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service
or a person with similar qualifications to avoid any danger.
ABOUT YOUR FACTORYFITTED PLUG
The cord is already fitted with a plug incorporating an appropriate fuse. If the plug does not fit your socket outlet, see paragraph below.
Should you need to replace the fuse in the plug supplied, an appropriately rated approved BS 1363 fuse must be used (refer to elec-
trical specification for use rating).
If the plug supplied does not fit your socket outlet, it should be removed from the mains lead and disposed of safely. The flexible cord
insulation should be stripped back as appropriate and a suitable alternative plug fitted.
If the plug has external access to the fuse (non-rewirable type plug) please note that the fuse cover is an important part of the plug.
Please ensure that it is always refitted correctly. If you lose this cover please do not use the plug. You may contact Rowenta UK Limited
for a replacement.
WIRING INSTRUCTIONS
Warning:
Important: the wires in this lead are coloured in accordance with the following codes:
Brown - Live, Blue - Neutral.
Connect the Brown wire to the terminal in the plug marked “L” or coloured Red.
Connect the Blue wire to the terminal in the plug marked “N” or coloured Black.
A 13 amp fuse should be fitted when the appliance is connected to a BS 1363A plug.
Seek professional advice if unsure of the correct procedure for the above.
VERY IMPORTANT :
NEVER COVER THE APPLIANCE, even temporarily, as there is a danger of overheating
(do not block the air inlets and outlets).
NEVER USE IT TILTED OR LYING ON ITS SIDE.
NEVER ALLOW WATER TO PENETRATE THE APPLIANCE.
In the event of a long absence: turn the button (A) to the initial setting ● and unplug
the appliance.
1 - USE IN THE BATHROOM
(protection against splashing with water)
This “ “ unit has been specially designed so that it can be
used in any room in your house, including those where there
is a risk of water being splashed onto it from above (kitchen,
bathroom, etc.).
However, the electrical installation in the room, the installation
of the unit and the way the unit is used must all comply with
the safety standards in force in your country.
Blue or
black
Brown
or red
Fit correct
fuse
Use cable
gripper
NOT 029640 Balnéa 24/09/02 16:33 Page 9