Filter
Top Products
7
ENGLISHFRANÇAISEESPAÑOL
2. PERIODIC INSPECTION
Periodic maintenance is vital to the safe and
efficient operation of your pump.
Check the table below for periodic maintenance
intervals.
IT IS ALSO NECESSARY FOR THE USER OF
THIS PUMP TO CONDUCT THE MAINTENANCE
AND ADJUSTMENTS ON THE EMISSION-
RELATED PARTS LISTED BELOW TO KEEP THE
EMISSION CONTROL SYSTEM EFFECTIVE.
The emission control system consists of the
following parts :
(1) Carburetor and internal parts
(2) Cold start enrichment system, if applicable
(3) Intake manifold, if applicable
(4) Air cleaner elements
(5) Spark plug
(6) Magneto or electronic ignition system
(7) Spark advance/ retard system, if applicable
(8) Exhaust manifold, if applicable.
(9) Hoses, belts, connectors, and assembles
The maintenance schedule indicated in the
following table is based on the normal engine
operation.
Should the engine be operated in extremely dusty
condition or in heavier loading condition, the
maintenance intervals must be shortened
depending on the contamination of oil, clogging of
filter elements, wear of parts, and so on.
Replace rubber pipes for fuel passage
every two years. If fuel leakage is found,
replace the pipe immediately.
CAUTION
Periodic Maintenance Schedule table
Maintenance Items
*Note 1: Initial oil change should be performed after first twenty (20) hours of operation. Thereafter change oil every hundred
(100) hours. Before changing oil, check for a suitable way to dispose of old oil. Do not pour it down
into sewage drains,
onto garden soil or into open streams. Your local zoning or environmental regulations will give you more detailed instructions
on proper disposal.
*Note 2: As to the procedures for these items, please refer to the SERVICE MANUAL or consult your nearest service dealer.
Every 8 hours
(Daily)
Every 50 hours
(Weekly)
Every 200 hours
(Monthly)
Every 500 hours Every 1000 hours
Clean pump set and check bolt and nuts
Check and refill engine oil
Change engine oil (*Note 1)
Clean spark plug
Clean air cleaner
Replace air cleaner element
Lubricate the pump-rod bearing
Clean fuel cup
Clean and adjust spark plug and electrodes
Replace spark plug
Clean spark arrester (Optional part)
Remove carbon from cylinder head (*Note 2)
Check and adjust valve clearance (*Note 2)
Clean and adjust carburetor (*Note 2)
Replace fuel lines
Overhaul engine if necessary (*Note 2)
(Daily)
(Yearly)
(Initial 20 hours)
Check and refill gear box grease
Check suction and delivery check valves
(Every 100 hours)
(Every 100 hours)
(Every 100 hours)
(Refill daily up to upper level)