Robertshaw RS5110 Thermostat User Manual


 
START/STOP SCHEDULE: Switches between running a schedule and
manual (permanent override). Cancels a temporary or vacation override.
EDIT SCHEDULE: Use this button to start editing the schedule. Push
repeatedly to move through the selections.
VACATION: Used to set a temporary setpoint for a number of days.
SET TIME: Sequences through the hour, minute and day.
LIGHT BAR: Turns on the display back light for 10 seconds.
FAN: Turns fan to AUTOMATIC, CIRCULATE or ON.
UP ARROW: Used during programming to increase the flashing item.
DOWN ARROW: Used during programming to decrease the flashing item.
HEAT/COOL: Sequences through OFF, HEATING, COOLING, and AUTO. If
you are using an RS5220 and it is configured as HP, emergency heat is
also displayed.
To Make Changes in the Schedule:
This thermostat can operate using a single setpoint by overriding the
schedules. If you will be using this thermostat for single setpoint operation
skip to
Overriding the Schedule.
Use the following table to document your schedule settings before editing
the schedule on the thermostat.
Press START/STOP SCHEDULE at any time to exit and save your settings.
Push EDIT SCHEDULE. The start time of the setpoint will be flashing.
6
TTiimmee CCooooll HHeeaatt
MMoorrnniinngg
DDaayy
EEvveenniinngg
NNiittee