Filter
Top Products
Programming Guide
SETTING TIME OF DAY AND
DAY OF WEEK
1. Press SELECT until the cursor is
over SET CLOCK. Press SET. The
HOURS segment will be blinking.
Use the or button to adjust
the hours setting. NOTE: The AM
or PM indicator will change as the
HOURS display rolls through a 24
hour cycle.
2. Press SET. The MINUTES segment will be blinking. Use the or
button to adjust the MINUTES setting.
3. Press SET. The DAY segment will be blinking at the top of the display.
Use the or button to adjust the day of the week. Press SET.
PROGRAMMING YOUR THERMOSTAT
The 8600 thermostat features 1-button programming. Simply follow these
steps to customize your thermostat for your lifestyle.
1. Place the HEAT-OFF-COOL switch into the HEAT position. Make sure
the cursor is in the RUN/SET PROG position. Press SET. The HOURS
segment will be blinking. MON thru FRI
(the work week) will be displayed across
the top. AM1 will be illuminated in the
lower right hand corner. You can now
start programming the first event of the
work week.
2. Use the or button to adjust the hour of the first event.
Press SET.
3. The MINUTES segment will be blinking. Use the or button to
adjust the minutes. Press SET.
4. The temperature should be blinking. Use the or button to
adjust the desired temperature of the first event. Press SET.
5. AM2 should now be displayed. Repeat
steps 2-4 to program the remaining events
(PM1 and PM2) for the work week. There
are a total of 4 events.
8
MON = MONDAY
TUE = TUESDAY
WED = WEDNESDAY
THU = THURSDAY
FRI = FRIDAY
SAT = SATURDAY
SUN = SUNDAY
select
set
heat off cool
hold
vac
prog
run/set
hold
temp
clock
set
auto on
MON
°
F
select
set
hold
vac
prog
run/set
hold
temp
clock
set
o on
Cursor
110-1097B 3/8/05 10:39 AM Page 8