RIDGID WD1950 Vacuum Cleaner User Manual


 
Maintenance
Push/Pull Handle
Cord Wrap
Power
Cord
Filter Cleaning
Your filter should be cleaned often to
maintain peak vac performance.
Be sure to dry the filter before storing or
picking up dry debris.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can cause a lot of dust to come out
of your vac. Replace it immediately.
Filter Removal
To remove the filter for cleaning or
replacement, unscre
w the filter n
ut from
the filter cage and lift off filter and filter
plate .
IMPORTANT: To a
v
oid damage to the
WARNING:To reduce the risk of
injury from accidental starting,
unplug power cord before changing
or cleaning filter.
NOTE:
The filter is made of high quality
paper designed to stop very small
particles of dust. The filter can be used
for dry pick up or small amounts of liquid.
Handle the filter carefully when removing
to clean or installing it. Creases in the
filter pleats may occur from installation
but will not affect the performance of the
filter.
Filter
Cord Wrap
When vacuuming is complete, unplug the
c
ord and wrap it around the power
assembly as shown. The cord should wrap
under the pull handle (above the inlet) and
around and under the cord wrap of the
motor cover.
blower wheel and motor, always reinstall
the filter before using the vac for dry
material pick-up.
Cleaning A Dry Filter
1. Some removal of dry debris can be
accomplished without removing the
filter from the vac. Slap your hand on
top of the lid while the vac is turned
off.
2. For best cleaning results due to
accumulated dust, clean the filter in an
open area. Cleaning SHOULD be
done outdoors and not in the living
quarters.
3. After filter removal from vac, remove
the dry debris by gently tapping filter
against the inside w
all of your dust
drum. The debris will loosen and fall.
4. For thorough cleaning of dry filter with
fine dust (no debr
is), run water
through it as described under
"Cleaning A
W
et Filter"
WARNING: Do not operate with
the filter cage and float removed.
The float prevents water from
entering the impeller and damaging
the motor.The cage prevents fingers
from touching the moving impeller.
!
13
!
Hose Storage
Area
SP6567 16 Gallon Steel.qxd 8/15/07 1:32 PM Page 13