Filter
Top Products
K-40 Drain Cleaner
Ridge Tool Company14
Autofeed
A drop of grease to the following areas once a month will
extend the life of the Autofeed unit and keep it well main-
tained.
a. Top of Large Top Adjustment Screw
b. Threads on Bottom of Top Adjustment Screw
c. Outside Diameter of Top Roller Holder housing
There are no grease fittings to worry about, however, the
autofeed will accumulate dirt, grease and debris over time.
It is a good idea to periodically remove the autofeed unit
and clean with cleaning solvent and a firm brush.
It is also a good idea to apply a light grease once a
week, to the autofeed roller bearing surface. This will ex-
tend the life of the bearings and keep them free to operate
properly.
Machine Storage
Motor-driven equipment must be kept in-
doors or well covered in rainy weather. Store the drain
cleaner in a locked area that is out of reach of children and
people unfamiliar with drain cleaners. This machine can
cause serious injury in the hands of untrained users.
Service and Repair
Service and repair work on this Drain Cleaner must be
performed by qualified repair personnel. Machine should
be taken to a RIDGID Independent Authorized Service
Center or returned to the factory. All repairs made by
Ridge service facilities are warranted against defects
in material and workmanship.
When servicing this machine, only iden-
tical replacement parts should be used. Failure to follow
these instructions may create a risk of electrical shock or
other serious injury.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
WARNING
WARNING