Filter
Top Products
8
9
Operation
Unpacking Your SummerBreeze Zone Heater
• Cut open the taped edges, remove the
protective packaging materials and lift heater
from carton. Find a level location to place the
unpackaged heater.
• Keep the packaging for off-season storage and
any transporting needs.
• Plug the power cord directly into an unused,
grounded 120 volt, 15 amps or higher circuit
receptacle.
Turning the Power On
Dial Thermostat Models
• Press the on/off switch to On. An amber light
will display on the front of the unit indicating the
heater is plugged into an electrical outlet and
turned on.
• Turn the thermostat dial to set the desired
temperature.
• If the thermostat is set above the room’s
temperature the heater fan will begin to
operate after a few minutes.
On/Off Switch
On/Off Switch
Dial Thermostat
Programmable Thermostat
Operation
Turning the Power On
Programmable Thermostat Models
• Press the on/off switch on the back of the
heater to On. An amber light will display on
the front of the unit indicating the heater is
plugged into an electrical outlet and turned
on.
• Slide the on/standby switch on the
thermostat to On. It is not necessary to
ever set the thermostat to Standby because
the master on/off switch on the heater
controls the power to the heating element.
• Set the desired temperature using the up/
down temperature adjustment buttons.
See Setting the Temperature (page 10) for
complete instructions.
• If the thermostat is set above the room’s
temperature the heater fan will begin to
operate after a few minutes.
Turning the Power Off
All Models
• Press the on/off switch on the back of the
heater to Off.
•
4
0
•
5
0
•
6
0
•
7
0
•
8
0
•
F°