Filter
Top Products
13
Installation
Low Voltage Connections
Connect the low voltage wires to the low voltage inlet on your unit.
To do so:
1. Strip wires over 1 cm (1/2 inch) (figure 10).
2. Gently press on the toggle to open the connector (figure 11).
3. Insert stripped wire (figure 12).
4. Release toggle to secure wir e in connector (figure 13).
5. Repeat for second wire.
To disconnect:
1. Gently press on the toggle to open the connector.
2. Remove low voltage wire fr om connector.
LED
Except H9 &
H11 models
details on
page 15