Filter
Top Products
12
13
Tools
On-board cleaning tools
(Models 8905, 8925 & 8955)
Select models are equipped with on-board cleaning tools
including 4-to-1 stretch hose, 3 piece telescopic wand,
crevice tool, dusting tool, upholstery tool.
• Remove hose cuff from the nozzle inlet (diagram 29).
• Remove the telescopic wand from the body of the
vacuum and connect it to the hose cuff (diagram 30).
Unlock wand collars, extend wand and re-lock
wand collars.
Note: Wand collar locking rotation is marked with arrows
on the wand. Cleaning tools can be used with the wand
extended or compressed or the tools can be used without
the wand by connecting the tools directly to the hose cuff
(diagram 31).
• Select the proper tool for your cleaning situation and
connect the tool to the end of the wand or cuff (diagram
32). NOTE: Tools store conveniently in vacuum body by
snap-fit.
Suction control dial
(Models 8905, 8925 & 8955)
The lid on the attachment port is a suction control dial
(Diagram 33). This feature is useful when less suction is
needed, for example, to clean drapes, throw rugs, etc. To
use, simply turn the dial to reduce the suction to desired
level. Close the dial for normal vacuum operation.
Note: When using an optional attachment hose with the
suction control dial feature, do NOT insert the attachment
hose into the attachment port. Doing so will bypass the
suction control dial features. Instead, attach the optional
hose to the hose cuff (located at the bottom back side of
the vacuum). Simply insert the hose cuff from the vacuum
cleaner into the cuff of the attachment hose. The hose cuff
is designed to fit into the optional attachment hose, thereby
allowing use of the suction control dial.
Operation
CAUTION:
First, disconnect the vacuum cleaner from the
electrical outlet.
Unclogging nozzle and hose
The nozzle hose, located on the back of the vacuum
cleaner, carries the dirt from the nozzle to the filter bag. The
hose also functions as the attachment cleaning hose. If the
hose should become clogged:
• Pull out and turn the lid of the cleaning attachment
opening. Remove the clog or blockage.
• If the above step is not enough, remove hose cuff from
the nozzle inlet (diagram 28). Turn the vacuum over and
unscrew the bottom plate and remove plate (see "How
To Remove Bottom Plate"). Check nozzle inlet tube for
obstructions. Clear tube and re-install the bottom plate
(diagram 29).
Full bag indicator light
The warning light is located on top of the bag compartment
(see diagram 30). The light will trigger if the vacuum bag
is full or if there is a clog in the vacuum cleaner. If the
light indicator turns on, check the vacuum bag. If it is not
full, check the vacuum cleaner for clogs by inspecting
the agitator area (see “Removing and re-installing bottom
plate”), hose and/or attachment inlet.
Please disregard the indicator light during attachment
cleaning. The light is designed to indicate air flow restriction
during carpet cleaning. When using cleaning attachments,
the indicator will light periodically due to normal attachment
air flow restrictions.
28
29
Nozzle
Inlet
Tube
28
30
29
31
32
33