Filter
Top Products
10
CLEANING AND MAINTENANCE
You should regularly carry out the cleaning and maintenance of the water chamber,
cover and cover seal as described in this section.
DISASSEMBLING YOUR HUMIDAIRE 3i
Please refer to the illustrations in section H of the illustration sheet.
!
WARNING
Beware of electrocution. Do not immerse your flow generator, docking station or
power cord in water. Always unplug the device before cleaning and be sure that it
is dry before plugging it back in.
1 Unplug the power cord from the power outlet (H-1).
!
WARNING
Take care when handling your HumidAire 3i. The water and the water chamber
base may both be hot. Allow ten minutes for the heater plate and any excess water
to cool (H-2).
2
Remove the water chamber from the docking station (H-3) and discard any excess
water (H-4).
3
Detach the air tubing from the air outlet (H-5).
4
Gently flex one cover arm away and up from the docking station until the cover
detaches completely (H-6 to H-8). Peel the cover seal away from the cover (H-9).
TUB PLATE
The tub plate should not be removed from the water chamber. If removed, replace
the tub plate by:
i. Turning the water chamber base upside down.
ii. As shown below, position the tub plate so that the open side is facing down. Then
firmly press the tub plate down into the water chamber.
!
CAUTION
The water chamber may leak if the tub plate is refitted incorrectly.
Note: The tub plate will not fit into the water chamber if it is facing up. Before fitting the
tub plate, make sure the O-ring is fitted snugly inside the groove of the tub plate.
tub plate
33804r2.book Page 10 Wednesday, May 25, 2005 2:54 PM