Reliance Water Heaters 317775-000 Water Heater User Manual


  Open as PDF
of 40
 
29
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a re or
explosion may result causing property damage, personal injury or loss of
life.
A. This appliance does not have a pilot. It is equipped with
an ignition device which automatically lights the burner.
Do NOT try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance area
forgas.Besuretosmellnexttotheoorbecausesome
gasisheavierthanairandwillsettleontheoor.
WHAT TO DO IF YOU SMELL GAS:
• Donottrytolightanyappliance.
• Donottouchanyelectricswitch;
Do not use any phone in your building.
• Immediatelycallyourgassupplierfromaneighbor’s
phone.Followthegassupplier’sinstructions.
• Ifyoucannotreachyourgassupplier,callthere
department.
C. Use only your hand to push in the gas control buttons.
Neverusetools.Ifthecontrolbuttonswillnotpushin,don’t
trytorepairthem,callaqualiedservicetechnician.Force
orattemptedrepairmayresultinareorexplosion.
D. Do not use this appliance if any part has been under
water.Immediatelycontactaqualiedinstallerorservice
agencytoreplaceaoodedwaterheater.Donotattempt
to repair the unit! It must be replaced!
OPERATING INSTRUCTIONS
1. SetthethermostattothelowestsettingbyrstpressingtheCOOLER and HOTTER buttons together and
holding for 1 second. Then press the COOLER
button until the WARM indicator light appears.
2. SettheON/OFFswitchontheblowercontrolboxtothe“OFF”position.
3. Turn off all electric power to the appliance if service is to be performed.
BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.
1. STOP! Read the safety information above,
on this label.
2. Setthethermostattothelowestsettingbyrstpressing
the COOLER
and HOTTER buttons together
and holding for 1 second. Then press the COOLER
button until the WARM indicator light appears.
3. Setthe“ON/OFF”switchontheblowercontrolboxto
the“OFF”position.
4. This appliance is equipped with a device which
automatically lights the burner.
DO NOT TRY TO LIGHT THE BURNER BY HAND.
5.Waitve(5)minutestoclearoutanygas.
Ifyouthensmellgas,STOP!Follow“B”in
thesafetyinformationaboveonthislabel.Ifyoudon’t
smell gas, go to the next step.
6. Turn on all electrical power to the appliance.
7. Setthermostattodesiredsettingbyrstpressingthe
COOLER
and HOTTER buttons together and
holding for 1 second. Then press the HOTTER
button.
8. If the appliance will not operate, follow the instructions
“TOTURNOFFGASTOAPPLIANCE”andcallyour
technician or gas supplier.
9. WATER TEMPERATURE ADJUSTMENT
isapproximately120°F.
CAUTION: Hotter water increases the risk
of scald injury. Consult the instruction
manual before changing temperature.
WARNING: TURN OFF ALL ELECTRIC
POWER BEFORE SERVICING
TO TURN OFF GAS TO APPLIANCE
 previous next